Installing The Vortech - Vortech MP60 Setup Manual

Installing the VorTech

SET UP YOUR
MP60
WATCH THE VIDEO:
4
ecote.ch/mp60qdsetup
STEP 1: Choose Pump Location
•
Where the pump output is unobstructed
•
High enough above the sand bed so sand is not disturbed
•
Sufficiently below the surface so air is not sucked into a vortex
STEP 2: Prepare Aquarium
•
Use an aquarium scraper to clean the inside surface of the
aquarium and a damp cloth to clean the outside.
•
Use caution when handling an aquarium scraper.
STEP 3: Attach Hanger and Mounting Tab
•
Apply hanger to aquarium glass directly above the pump
mounting location (Figure A).
•
Peel backing off of adhesive and place mounting tab a few inches
above the desired mounting location on the outside
of the aquarium (Figure B).
™