Installing the VorTech
SET UP YOUR
MP10
WATCH THE VIDEO:
4
ecote.ch/mp10qdsetup
STEP 1: Choose Pump Location
•
Where the pump output is unobstructed
•
High enough above the sand bed so sand is not disturbed
•
Sufficiently below the surface so air is not sucked
into a vortex
STEP 2: Prepare Aquarium
•
Use an aquarium scraper to clean the inside surface of
the aquarium and a damp cloth to clean the outside.
•
Use caution when handling an aquarium scraper.
STEP 3: Attach Mounting Tab
•
Peel backing from the adhesive and place the tab 2-3"
above the desired mounting location on the outside of
the aquarium (Figure A).
™