Advertisement
3. Using the supplied bracket template (pg. 8), mark
the location of the holes that need to be drilled
in the wall, being careful to make sure that the
wall behind is clear of electrical wiring, plumbing,
pipes etc. Note: Be sure to set the height of the
rangehood between the minimum and maximum
height requirements as per diagram Fig. 1( Pg. 3).
This can be done by measuring from the lowest
point of the rangehood to the horizontal support
bar. (Fig. 4)
NOTE: Model measurements will vary.
Please check specific model specs.
4. Using an 8mm drill bit, pre-drill the holes that
will hold the bracket to the wall. (Using bracket
template, or physical bracket for reference.)
5. Insert the supplied plastic dowels to the pre-
drilled holes and fix bracket to the wall with the
supplied screws. (Note: Please use a spirit level to
make sure the bracket is perfectly level.)
6. Once the bracket is secure, using two people,
lift the hood and drop the horizontal support bar
onto the fixed bracket (Fig. 5).
(Note: There are additional holes on the inside of
the hood to secure the rangehood flush to the wall
and completely stable. (Hole locations will vary per
model.)
7. Connect your Sirius ducting (see www.
siriusbrand.com for approved ducting) to the
outlet collar on the rangehood and secure in
place with a ring clamp if you are using semi rigid
ducting. If you are using solid/rigid ducting and
external duct connector is required. (Note: do not
fix the ducting in place with screws as they will
prevent the movement of the non-return valves).
Complete all of the duct work to the motor
location before fixing the flue covers in place to
ensure the ducting has not come free. (See www.
siriusbrand.com for motor installation guides.)
8. Insert the upper flue cover into the lower flue
cover and mount into the channel on the top of
the rangehood. There are two spring loaded clips
that need to be on the inside of the lower flue
cover to secure in place. (Fig 6.)
(Fig. 4)
9. Telescope the upper flue cover to the ceiling and
mark with a pencil the outer line of the cover, this
will give you the exact location of where the top
fixing bracket needs to be fitter to the ceiling.
10. Fix the top fixing bracket into place using the
supplied 30mm screws (Fig.7).
(Fig. 5)
7
(Fig. 6)
(Fig. 7)
Advertisement
