Hunter Hydrawise HC Owner's Manual page 6

Irrigation controllers

Hide thumbs Also See for Hydrawise HC:

X2 w/WAND WiFi Module

NOTE: With an HC Hydrawise controller, any one of your 6 or 12 zones can be configured

to act as the pump start relay. We usually recommend wiring to the last zone that is not

being used in the controller.

Wiring to Power Source

Connecting the pump start relay should only be done by a licensed electrician following

local codes. Improper installation could result in shock or fire hazard.

1. To prevent electric shock, turn the main circuit-breaker switch to "off" prior to making

electrical connections.

2. Assemble conduit piping and connect AC power from the power source to one side

(LINE IN) of the relay.

3. Assemble conduit piping and connect wiring from the pump motor to the other side of

the relay (LOAD OUT).

4. Check to make sure there are no exposed or loose connections.

Software Setup

Table of Contents

Show Quick Links