Table of Contents
Advertisement
INSTALLATION
INSTALLING THE CONDENSING WATER
OUTLETS
1.
Open the doors of the unit.
2.
Remove the front panel of the base by undoing the two hexagon
screws.
3.
Remove the body of the condensing water outlet (A) from the
housing (B) and remove the tension pin (C).
4.
Push the main body of the condensing water outlet downward from
above, through the hole in the bottom plate of the ventilation unit.
5.
Push the tension pin downward from below towards the main body.
6.
Place the valve ball inside the housing of the condensing water
outlet.
7.
Attach the housing to the condensing water outlet.
8.
Install the second outlet in the same way.
9.
To reassemble the ventilation unit, follow the above steps in
reverse order.
MEASURING TUBES
The accessories delivered with the unit include four airflow
measuring tubes. These can be inserted in the ducts to allow for
easier ventilation adjustment.
92
1
16
2X
43
DV245
(Integral CO
WARNING
Water must not be allowed to enter
the electrical system.
A
2x
C
B
© Airflow • We reserve the right to make changes without prior notice
Sensor)
2
Advertisement
Table of Contents
