Advertisement
Route the cables through the cable-management arm and secure the cables to
8.5
the cable-management arm.
Configure the Ethernet interface on the PC to an IP address and subnet mask
8.6
within the same subnet as the server. This is the IP address for the service
processor.
Note: If you do not know how to do this, see the instructions in the IBM Systems
Hardware Information Center. For details about how to access the information
center, see task 9 Finish your system setup.
Possible values:
Server connector
HMC1
HMC2
For example, if you connected your PC to HMC1, the IP address for your service
processor might be 192. 1 68.2. 1 and the subnet mask would be 255.255.255.0. Set
the gateway IP address to the same IP address as that of the PC.
Using a Web browser, enter the IP address into the
8.7
to the port to which your PC is connected. For example, enter https://192. 1 68.2. 1 47 .
At the login prompt, enter the following default user ID and password:
8.8
User ID
admin
8.9
When you are prompted, change the default password.
Change the state of the system server firmware.
8.10
1.
In the navigation area, expand
2.
Click
Power On/Off System
3.
Select
Standby
4.
Click
Save settings and power on
Subnet mask
255.255.255.0
255.255.255.0
Password
admin
Power/Restart Control
.
in the Boot to system server firmware field.
IP address
192.168.2.147
192.168.3.147
Address
.
field that corresponds
.
Advertisement
