Table of Contents
Advertisement
1. When operating machine, stand off to the side of the feed hopper when feeding wood into the
machine. NEVER STAND DIRECTLY IN FRONT OF THE FEED HOPPER WHEN FEEDING
WOOD INTO THE MACHINE.
2. When using the chipper and you have a short piece of wood bouncing around and not being grabbed
by the feed roll, LEAVE IT! DO NOT TRY TO PUSH IT THROUGH WITH ARMS OR LEGS!
The next limb will push it through.
3. When through with the job, let the engine run at full R.P.M., making sure all the material has run
through the machine before shutting it down. This will prevent any injuries from flying debris
when the machine is started up at the next job.
4. COUNT YOUR EXTREMITIES AGAIN. BE SURE THIS NUMBER MATCHES YOUR
STARTING NUMBER.
5. There is nothing funny about this machine. It has no mercy and will not slow down.
•
STAY ALERT!
•
PAY ATTENTION!
•
KNOW YOUR FELLOW CO-WORKERS WHEREABOUTS AT ALL TIMES!
•
NEVER LET ANYONE OPERATE THIS MACHINE WITHOUT THE PROPER
TRAINING!
•
REMEMBER, THIS MACHINE CAN CHIP UP A TELEPHONE POLE IN 1-
MINUTE!
O:\Manuals\818 MANUAL\818 Manual P.W. rev (2) 09-2019.doc
OPERATING PROCEDURE HINTS
- 9 -
Advertisement
Table of Contents
