Sharp CD-BK133W Operation Manual page 22

Recording to a cassette tape (continued)
CD-BK133W
! Recording from the radio
1
Tune in to the desired station. (See page 16.)
2
Load a cassette into the TAPE 2 cassette compartment with the
side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be performed.
3
Press the REC PAUSE
button.
Recording will be paused.
4
Press the / button on the
main unit or the TAPE 2
on the remote control to start re-
cording.
To interrupt recording:
Press the REC PAUSE ( ) button.
To resume recording, press the
To stop recording:
Press the (TAPE ) button.
Note:
If you hear a whistling noise whilst recording an AM station, move the AM loop aerial.
Erase-prevention tab of cassette tapes:
" When recording on a cassette tape, make
sure that the erase-prevention tabs are not re-
moved. Cassettes have removable tabs that
prevent accidental recording or erasing.
" To protect the recorded sound, remove the tab
after recording. Cover the tab hole with adhe-
sive tape to record on the tape without the tab.
E-21 ENGLISH
( )
button
/ (TAPE 2 ) button.
Side A
Tab for side A
Tab for side B
Listening to the radio (See page 16.)
! Dubbing from tape to tape
You can record from TAPE 1 to TAPE 2.
For recording, use only normal tapes. Do not use metal or CrO tapes.
1
Press the ON/STAND-BY button to turn the power on.
2
Load a prerecorded cassette into
the TAPE 1 cassette compart-
ment. Insert a blank tape into the
TAPE 2 cassette compartment.
It is recommended that the recording
tape is the same length as the master
tape.
3
Press the TAPE (1 2) button un-
til "TAPE 1" appears on the dis-
play.
4
Press the REC PAUSE ( )
button.
Recording will be paused.
5
Press the / button on the
main unit or the TAPE 2 button
on the remote control to start
dubbing.
To stop dubbing:
Press the (TAPE ) button.
TAPE 1 and TAPE 2 will simultaneously stop.
! Erasing recorded tapes
1 Load the tape to be erased into the TAPE 2 cassette compartment with the side to
be erased facing toward you.
2 Press the TAPE (1 2) button until "TAPE 2" appears on the display.
3 Press the REC PAUSE ( ) button.
4 Press the / button on the main unit or the TAPE 2
control to start erasing.
Note:
Make sure that the TAPE 1 is not in use.
01/7/3 CD-BK133W(X)E3.fm
button on the remote