Cleaning The Hepa Filter; Troubleshooting - AmazonBasics B0716T5FW2 Manual

3.0 l vacuum cleaner (12m) with bag
Hide thumbs Also See for B0716T5FW2:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 4
Place the filter back into the cover and slide it back in.

Cleaning the HEPA Filter

Lift the exhaust grid to remove it.
Take out the HEPA filter
Rinse the filter under cold water.
Dry it afterwards.
Refit it to its original position.
Reinstall the exhaust grid until it clicks in place.
NOTICE

Troubleshooting

Problem
The appliance does not start.
Weak suction power.
Motor is abnormally noisy.
12
9
.
Never use the appliance without filters installed. This can
cause power loss or damage to the appliance.
Solution
Connect the power plug properly.
Check if the electrical outlet is powered.
Check if the on/off switch is on.
Check if the flexible hose, extension tube or
any of the accessories are obstructed.
Remove and clean the filters.
Stop using the appliance immediately.
Check if the hose, tube or any of the
accessories are obstructed.
Remove the obstruction.
If the noise continues, power off the appliance
and disconnect the power plug.
Contact your service agents.
6

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the B0716T5FW2 and is the answer not in the manual?

This manual is also suitable for:

B0711ms9dxB07c3n6bkx

Table of Contents