Gardena 11120 Operator's Manual page 3

EN GARDENA Pressure Sprayer 1.25 l
Translation of the original instructions.
Please read the operating instructions carefully and observe the notes given.
Use the instructions to familiarise yourself with the Pressure Sprayer, its proper
use and the notes on safety. For safety reasons, children under 16 as well as
persons not familiar with these operating instructions must not use the Pressure
Sprayer. Never operate the product when you are tired, ill or under the influence
of alcohol, drugs or medicine.
Read the operator's manual carefully before use and keep for future reference.
Intended use:
The GARDENA Pressure Sprayer is intended for distributing solvent­free liquid
pesticides , herbicides , fertilisers
1) 1)
domestic gardens and allotments. It must not be used in public places, parks,
sport arenas, or in agriculture or forestry. Compliance with the specifications
in this operating manual is a requirement for the proper use of the Pressure
Sprayer.
According to the Plant Protection Law as well as the Detergents and Cleaning Agents Law, only
1)
approved agents may be used (authorised specialist dealers).
Please note:
Due of the risk of physical injury, the GARDENA Pressure Sprayer must not be
used for spraying substances other than those specified by GARDENA.
Also, no acids, disinfectants or impregnators, aggressive and solvent­containing
cleaning agents, petrol or spray oil may be sprayed.
1. SAFETY
Danger of physical injuries:
Never open the Pressure Sprayer or unscrew the nozzle and the dosing cap
when the Pressure Sprayer is still pressurised. To prevent injury, never connect
the Pressure Sprayer to an air­compressor. Always hold the Pressure Sprayer
upright before the safety relief valve
When spraying insecticides, herbicides and fungicides or other liquid plant
protection products, you must comply with all special precautionary measures
specified by the manufacturer of the product you are using.
Before each opening of the Pressure Sprayer, thoroughly release
pressure by pressing the safety relief valve
DANGER! Small parts can be easily swallowed. There is also a risk that the
polybag can suffocate toddlers. Keep toddlers away when you assemble the
product.
Operation:
CAUTION: The tank may only be filled with a maximum of 1.25 litres
liquid. Inspect the Pressure Sprayer visually before each use. Never leave your
Pressure Sprayer unattended or for long periods when full and pressurised.
Keep the unit out of the reach of children. You are responsible for the safety
of others. Keep your Pressure Sprayer away from heat sources and hot
environments. Screw on the spray nozzle
(7) (Fig. O1) is positioned correctly.
and ensure that the O­ring
Cleaning:
Release the pressure after each use, empty the container, clean it carefully and
rinse with clear water. Then leave the pressure sprayer open and allow it to
dry. Do not dispose of residual fluids in the sewerage system (local disposal
systems). Always clean the Pressure Sprayer before using a different product
to avoid chemical reactions. When using several Pressure Sprayers, the tanks
and spray nozzle may not be exchanged between them. We recommend
that you have your Pressure Sprayer thoroughly inspected (preferably at
a GARDENA Service Centre) after using it for 5 years.
Storage:
Before storing, loosen the tank cap and always empty your Pressure Sprayer
completely (also after cleaning with water). Store away from frost.
Carry the pressure sprayer by the handle
Make sure that the product is protected from direct sunlight. The product may
heat up.
2. OPERATION
Please observe the safety and proportioning instructions provided by the
manufacturer of the product you are going to spray.
To spray the liquid [Fig. O1/O2/O3 ]:
1. Push the safety relief valve (6) .
(1)
2. Unscrew the spray head or the dosing cap
3. If necessary, fill in an additive via the dosing cap
(Scale (12) with 10 and 20 ml).
4
, window cleaners , and car wax
1) 1)
(6) (Fig. O3) is pressed.
(6)
.
(1)
tightly by hand (do not use tools)
(13) and not by the pump handle
(11)
and fill the container
(11)
.
4. Screw the spray head
4. Pump with the pump handle
5. Adjust the spray jet (clockwise rotation v spray mist; counterclockwise
rotation v spray jet) and the spray angle via the nozzle
6. Push the button
3. MAINTENANCE
To clean the pressure sprayer:
Always clean your Pressure Sprayer after spraying. Use the Pressure Sprayer
only with clear water (possibly with addition of dish detergent) and spray empty.
The valves, the suction hose and the nozzle
in
1)
outer dirtying of cover and tank, thoroughly clean the area thread and thread­
O­ring (7) .
4. STORAGE
To put into storage:
1. Clean the pressure sprayer (see 3. MAINTENANCE).
2. Store the pressure sprayer in a frost­free place.
5. TROUBLESHOOTING
To clean the filter [ Fig. O1 ]:
v Remove the filter
Problem
Pump does not build up
pressure
Pressure Sprayer does not
spray although there is
sufficient pressure or only
sprays with a weak spray jet
It is difficult to open and
close the container
NOTE: For any other malfunctions please contact the GARDENA service
department.
6. TECHNICAL DATA
Max. capacity
Permissible working pressure
Max. permissible operating temperature
7. SERVICE / WARRANTY
In the event of a warranty claim, no charge is levied to you for the services
provided.
GARDENA Manufacturing GmbH offers a two­year warranty (effective as of the
(3) .
date of purchase) for this product. This warranty includes all significant defects
of the product that can be proved to be material or manufacturing faults.
This warranty is fulfilled by supplying a fully functional replacement product or
by repairing the faulty product sent to us free of charge; we reserve the right
to choose between these options. This service is subject to the following provi­
sions: The product was used for its intended purpose as per the recommenda­
tions in the operating instructions. Neither the purchaser nor a third party has
attempted to repair the product. This manufacturer's warranty does not affect
warranty entitlements against the dealer / retailer. If problems arise with this
product, please contact our Service department or send the defective product
along with a brief description of the fault to GARDENA Manufacturing GmbH,
(2) making sure to have sufficiently covered any shipping costs and to have fol­
.
lowed the relevant postage and packaging guidelines. A warranty claim must
be accompanied by a copy of the proof of purchase.
(1) or dosing cap (11)
back onto the container.
(3)
.
(5)
to spray the liquid.
(4) are cleaned. In the case of
(10) from the suction hose and clean it.
Possible Cause
(1) (11)
Spray nozzle or cap
too lightly screwed on.
(8)
Pump pipe is loose.
(7)
O-Ring is not correctly
positioned.
Sealing cap (9)
is dirty /
defective.
(4)
Nozzle is blocked.
(10)
Filter is clogged.
Container pressure too high.
(4)
.
Remedy
(1)
v Screw on spray nozzle
(11)
or cap on tighter.
(8)
v Screw on pump pipe
tighter.
v Check correct position of
(7)
O-Ring .
v Clean / exchange sealing
(9)
cap .
(4)
v Unscrew nozzle and clean.
(10)
v Remove filter from the
suction hose and clean it.
v Release the container pres-
sure completely by means of
(6)
the safety relief valve .
1.25 l
3 bar
40 °C