Advertisement
•
Set the base on a level surface and insert the end caps then remove the four
screws.
•
Using these four screws, fix the stand outer tube to the base and securely tighten
the screws.
•
Temporarily remove the height adjustment collar then slide the base cover trim
down the tube to cover the fixing with the base. Refit the adjustment collar.
•
With the height adjustment collar loosened off, extend part of the inner tube. Re-
tighten the height adjustment collar.
•
Loosen the locking screw at the bottom of the switch/motor assembly and insert
the inner tube of the stand into it and push home. Re-tighten the screw.
•
Unscrew the rear guard retaining nut from the motor shaft.
•
Fit the rear guard onto the body of the fan. Use the two pegs provided to align with
the two holes in the rear guard.
•
Lock into position by firmly tightening the rear guard retaining nut.
•
Push the fan blades onto the motor shaft aligning the slots. Lock into position by
firmly tightening the retaining ring.
•
If not already attached, fit the decorative cap to the front guard using the screws
supplied.
•
Mount the Front Safety Grill onto the Rear Grill by hanging the top hook clip of
front grille over the top of the Rear Grill. Close the clasps all around the grill, finally
fit the nut and screw through the hole in the bottom edge of the front grill and
tighten.
OPERATION
•
Connect the mains plug to a suitable outlet.
•
Select the desired speed using the speed control:
0 = Device off
1 = Low speed
2 = Medium speed
3 = High speed
•
The inclination of the fan head can be adjusted by tilting it forwards and
backwards. The fan head can then be locked into position, which is indicated by
an audible click.
•
Oscillation: to make the fan oscillate, push down the oscillation knob. To stop the
fan head from oscillating, pull up the oscillation knob.
•
To adjust the height, slacken the height adjustment collar and slide the upper
section to the required height. Re-tighten the height adjustment collar.
CLEANING & STORAGE
•
Before cleaning, turn the fan off and unplug from the power supply.
•
Use a soft cloth to wipe off any dust. If the fan is very dirty, use a damp cloth and
wipe dry.
•
Do not use any chemicals, abrasives or solvents that could damage the fan.
•
Store the fan in its original packaging in a ventilated dry area.
•
The motor bearings are permanently sealed and do not require additional
lubrication.
Advertisement
