Step 2 Fixing The Outdoor Unit In Place - Samsung AC RXAD G Series Installation Manual

Installation Procedure
Moving the outdoor unit with wire rope
1 Before carrying the outdoor unit, fasten two wire
ropes of 8 m or longer, as shown in the figure.
2 To prevent damages or scratches effectively, insert
a piece of cloth between the outdoor unit and the
ropes.
3 Move the outdoor unit.

Step 2 Fixing the outdoor unit in place

Install the outdoor unit on a rigid and stable base to
prevent disturbance from any noise caused by vibration.
When installing the unit at a height or in a location
exposed to strong winds, fix the unit securely to a
support (i.e., a wall or a ground).
Fix the outdoor unit with anchor bolts. Make sure that
the anchor bolts are 20 mm or higher from the base
surface.
Anchor bolt hole
10
English
Wire rope
Plate protection
cloth
(Unit : mm)
CAUTION
• Install a drain outlet at the lowest end around the
base for outdoor unit drainage
• When installing the outdoor unit on the roof,
waterproof the unit and check the ceiling strength.
• Make sure that the wall can support the weights of
the rack and the outdoor unit.
• Install the rack close to the column as much as
possible.
Optional: Fixing the outdoor unit to a wall with
a rack
Designed to cut off residual vibration from
outdoor unit to rack. (not supplied with product)
Anchor bolt
Base surface
Soft rubber designed to cut off vibration from
rack to wall. (not supplied with product)
• Install a proper grommet in order to reduce noise and
residual vibration transferred by the outdoor unit
towards the wall.
CAUTION
• When installing an air guide duct, be sure to check
the following:
– The screws do not damage the copper pipe.
– The air guide duct is fixed firmly on the guard fan.