Advertisement
Installing The Product
Installing The Meter
A Installation with the Meter Holder
1. F a s t e n u s i n g t h e
double-sided tape.
Double-sided
tape
Clean
to remove
oil and dust
Note : Please be sure about
where you wish to install the
meter, as it is not advisable to
reuse double-sided tape.
B Installation to panel or something
Cut the Cushion Tape in half, affix to base of the Meter to be on press
fit condition with adjusting number. And connect the Gauge Cable to
the Meter and insert into the panel.
Cushion Tape
Cut the Cushion
Tape in half
Cushion Tape
Installing The Unit
As shown in the below diagram , fasten the unit
into positions not usually affected by water.
(Example of Installation)
Under the steering
On the back side
column cover
of the under cover
Do not install into low positions
Basic Operation
1
2
Engine Start
Opening Demo
•When the engine starts, the needle will move to the extreme left several
Opening
times for searching position. Then it will move to the maximum value
Demo
and finally to reading for current measurement item.
•Due to analyzation time for the car data transmission it may take up to a
few seconds from engine start before opening demo.
2.After deciding the position
and angle of the meter face,
fasten the Hexagonal bolt
on both sides to secure.
Hexagonal bolt
Panel
Gauge
Cable
Fastening
to Flat Space
Unit
On the inside of
the driver's door
3
Display Each Mode
3.Affix the
to the base of the meter, connect the Gauge Cable to the
Cushion Tape
Meter, and install the Meter into the Meter Holder.
if the Meter not fixed.
Cushion Tape
Meter Holder
Cushion Tape
Gauge Cable
C Installation to A-pillar using A-pillar Stand
Make a
5 hole on the place to install the meter of the A-pillar, and fix the
ø
Meter using A-pillar Stand with Screw and Nut.
Screw
A-pillar
Stand
When Fastenings to
a Cable or Pipe
Zip tie
(Large)
Double-sided
tape
Clean to
remove
oil and dust.
4
Engine Stop
•Due to analyzation time for the car data transmission, the
Turning off
illumination may remain on for up to 1 minutes even after
the Display
the engine has been turned off; this is normal and no
effect on the vehicle performance. (except wiring IGN)
Please add the Cushion Tape
Cushion Tape
Back side
of Meter
Connector
A-pillar
A-pillar
Nut
ø5 Hole
Through
holes
Thick cable
or pipe
5
Meter OFF
The needle stops
in the vicinity of
lowest value.
3
Advertisement
