Edge-Core CSR200 Quick Start Manual

Quick Start Guide
Cell Site Gateway
AS5915-18X
1. AS5915-18X
2. Rack Mounting Kit—2 brackets and 8 screws
3. Grounding kit—grounding lug, 2 screws, and 2 washers
4. Ring lugs (x4)
Caution: The device must be installed in a restricted-
access location.
Attention: le périphérique doit être installé dans un
emplacement à accès restreint.
Note: The router has the Open Network Install
Environment (ONIE) software installer pre-loaded on the
router, but no software image. Information about
compatible software can be found at
www.edge-core.com.
Note: The drawings in this document are for illustration
only and may not match your particular model.
1
Attach the Brackets
1
1. Attach each of the brackets to the router with four of the included
bracket screws.
2
Mount the Router in an EIA-310 Rack
1
1. Use the screws and cage/clip nuts supplied with the rack to
secure the router in the rack.
*150200002xxxH_R01*
Package Contents
1
2
3
5. Category 6 stacking cable
6. Documentation—Quick Start Guide (this document) and
Safety and Regulatory Information
3
Ground the Router
Rear Panel
1. Ensure the rack is properly grounded and in compliance with
international and local standards. Verify that there is a good
electrical connection to the grounding point on the rack (no
paint or isolating surface treatment).
2. Attach the grounding wire (#6 AWG/16 mm
point on the router's rear panel or side panel. Then connect the
other end of the wire to rack ground.
Caution:
all supply connections have been disconnected.
Attention:
sauf si toutes les connexions d'alimentation ont été
débranchées.
4
Connect Power
1. Connect an external DC power source to the PSUs. Or, connect
to a no-tolerance DC mains supply with a UL/CSA-approved
circuit breaker rated at 16 A.
Caution:
router, ensure that power to the feed lines is turned off at the
supply circuit breaker or disconnected from the power bus.
Attention:
au routeur, assurez-vous que l'alimentation des lignes
d'alimentation est coupée au niveau du disjoncteur
d'alimentation ou déconnectée du bus d'alimentation.
– 1 –
www.edge-core.com
5
4
2
Side Panel
1
The earth connection must not be removed unless
Le raccordement à la terre ne doit pas être retiré
1
Before connecting power supply cables to the
Avant de connecter les câbles d'alimentation
6
2
2
) to the grounding
E012021-CS-R01
15020000xxxxH