Special Wash Cycles And Options - Whirlpool ADP 402 Operating Instructions Manual

Special wash cycles
and Options
Notes:
EN
Optimum performance levels when using the "1 Hour and Rapid"
cycles can be achieved by respecting the specified number of
place settings.
To reduce consumption even further, only run the dishwasher
when it is full.
Note for Test Laboratories: for information on comparative EN
testing conditions, please send an email to the following address:
contact@whirlpool.com
Wash options
The OPTIONS may only be set, changed or reset after the wash
cycle has been selected and before the Start/Pause button
has been pressed.
Only the options which are compatible with the type of wash cycle
set may be selected. If an option is not compatible with the selected
(see Table of wash cycles)
wash cycle
symbol flashes rapidly 3 times.
If an option is selected which is not compatible with another
(previously selected) option, it will flash 3 times and switch off,
while the most recently selected option will remain active.
To deselect an option which has been set by mistake, press the
corresponding button again.
Delayed start
The start of the program may be delayed for
a period of time between 0:30 and 24 hours.
1. Select the program and any desired options. Press the DE-
LAYED START button (repeatedly) to delay the start of the
program. Adjustable from 0:30 to 24 hours.
With each press of the button, the delay start increases
by: 0:30 if selection below 4 hours, 1:00 if selection is be-
low 12 hours, 4 hours if selection is above 12 hours. If 24
hours reached, and the button is pressed, the delayed start is
deactivated.
2. Press the START/PAUSE button: the timer will begin
counting down;
3. Once this time has elapsed, the indicator light switches
off and the program begins automatically. If at the time of
the countdown the START/PAUSE button is pressed again
the DELAYED START option is cancelled and the selected
program starts automatically.
The Start Delay function cannot be set once a wash cycle
has started.
Drain out
To stop and cancel the active cycle, the DRAIN OUT
function can be used.
A long press of START/PAUSE button, will activate the DRAIN
OUT function. The active cycle will be stopped and the water in
the dishwasher will be drained out.
24
detergent. Select the wash cycle and then press the MULTIZONE
button: the indicator corresponding to the chosen rack lights up
and the wash cycle starts only in the upper or lower rack.
Remember to load the upper or lower rack only, and to reduce
the amount of detergent accordingly.
CHILD LOCK function. The CHILD LOCK function will block the
control panel. To deactivate the CHILD LOCK, long press again.
, the corresponding led/
the indicator light will switch on. To deselect the option, press the
same button again.
Ideal to clean crockery and feeding bottles.
the end of the cycle.
The
To deactivate the TAB option, long press again.
The TAB option results in a longer wash cycle.
Multizone Option/Child Lock
If there are not many dishes to be washed, a half load
cycle may be used in order to save water, electricity and
Child lock option
A long press of MULTIZONE button, will activate the
Sani Rinse option/Tab
This option allows higher temperatures to be used. Select
the washing program, press the SANI RINSE button and
Warning: the crockery and plates could be extremely hot at
SANI RINSE option results in lengthening of the wash cycle.
Tablet option (Tab)
A long press of SANI RINSE button, will activate the TAB
function. This option optimises washing and drying results.