Start And Stop Motor - Fujitsu F2MC-8FX Series Setup Manual

3.3 Start and Stop Motor

When the LED1 is off, it means motor is stopped. If you want to start the motor, press the
start/stop key, and the LED1 turns on. It means motor is running. At the same time, you can
see that motor is rotating. If you want to stop the motor, press the start/stop key again, and
the LED1 turns off. It means motor is stopped. At the same time, you can see that the motor
is stopped. Refer to Figure 3.3.
LED1
Start/stop key
EV Board MB2146-440-E Setup Guide
Chapter 3 EV Board Operation
Hall sensor/B-EMF Key LED3
Figure 3.2
Figure 3.3
Page 17
1 2 3
J1
J2
J3