Foreword - AWG Z2 Operating Manual

AWG I Operating manual I Fittings I

FOREWORD

Applicable standards and regulations
The design and construction of the AWG Inductors Z2, Z4 and Z8,
Types L "Leicht" and S "Schwer" [Light and Heavy, respectivly] was
carried out in accordance with the relevant provisions laid down by
these directives and the harmonised standards:
DIN 14384:2011-01 Schaummittel-Zumischer PN 16, selbstansaugend
[Inductor proportioner PN 16 for foam compound]
Conversions and modifications
Unauthorised conversions or modifications to the inductors are pro-
hibited without written consent from the manufacturer.
AWG Fittings GmbH accepts no liability for damage caused by conver-
sions or modifications, improper handling by the customer or by third
parties commissioned by the customer, or caused by non-compliance
with these instructions.
Applicable Documents
Apart from this manual, no other applicable documents are required for
the safe handling of the AWG Inductors.
The data sheet for this device can be downloaded from our website:
www.awg-fittings.com
Copyright
This operating manual is valid for the devices
AWG Inductors Z2, Z4 and Z8, Types L "Leicht" and S "Schwer" [Light
and Heavy, respectively]
© AWG Fittings GmbH Revision: 01 of 20/02/2020
All rights to this document are reserved by AWG Fittings GmbH.
The document may not be copied or reproduced in whole or in part
without the written permission of AWG Fittings GmbH. The document
is intended for persons using the device described and must not be
passed on to third parties.
Subject to technical changes and errors.
These instructions and the applicable documents are not subject to
any automatic change service. The latest version can be obtained from
the manufacturer.
M1061B10 I Rev. 01-02/20
Inductors Z2, Z4 and Z8
ENGLISH
FOREWORD
21 / 40