Itpms System (Indirect Tyre Pressure Monitoring System) - Fiat FIORINO Owner's Handbook Manual

52) Do not take unnecessary risks, even if
your vehicle is fitted with this system.
Your driving style must always be suited to
the road conditions, visibility and traffic.
The driver is always responsible for road
safety.
53) The HBA system cannot overrule the
natural laws of physics, and cannot
increase the grip available according to the
condition of the road.
54) The HBA system cannot prevent
accidents, including those due to excessive
speed on corners, driving on low-grip
surfaces or aquaplaning.
55) The capability of the HBA must never
be tested irresponsibly and dangerously, in
such a way as to compromise personal
safety and the safety of others.
76
iTPMS System
(indirect Tyre
Pressure
Monitoring System)
(for versions/markets, where provided)
The indirect Tyre Pressure Monitoring
System iTPMS can monitor the tyre
inflation status through the wheel speed
sensors. The system warns the driver
if one or more tyres are flat by switching
on the warning light on the
instrument panel and a warning
message on the display, along with an
acoustic signal.
It is advisable to check the pressure of
all four tyres. This indication is displayed
also when turning the engine off and
on until the "Reset" procedure is carried
out.
"Reset" procedure
The iTPMS needs an initial "self-
learning" phase (with length depending
on the driving style and road conditions:
optimal conditions being driving on a
straight road at 80 km/h for at least 20
minutes) which starts when the "Reset"
procedure is carried out.
The "Reset" procedure must be carried
out:
each time tyre pressure is modified;
when even only one tyre is changed;
when tyres are rotated/inverted;
when the space-saver wheel is
fitted. Before carrying out the "Reset"
procedure, inflate the tyres to the rated
pressure values specified in the inflation
pressure table (see "Wheels" paragraph
in the "Technical specifications"
chapter).
If the "Reset" procedure is not carried
out, in all above cases, the
light may give false indications on
one or more tyres.
To carry out the "Reset" procedure,
with the vehicle stopped and the
ignition device at MAR, use the Setup
Menu as follows:
briefly press the button: the
display will show "Reset";
press the button or the
button to select ("Yes" or "No");
briefly press the button: the
display will show "Confirm";
press button or
("Yes" to "Reset" or "No" to exit the
video page);
press the button again to return
to the standard screen or to the main
menu according to where you are in the
menu.
After the "Reset" the display will show
the "Reset saved" message, indicating
that the "self-learning" has been
started.
warning
to select