System Setup & Operation - JTS IT-12 User Manual

4. System Setup & Operation
4-1 General Description
This chapter provides a comprehensive and detailed description on how to setup and op-
erate IT-12 Interpreter System Main Unit (IT-12M4) and Interpreter Console (IT-12D).
(1)OPEN Mode: Interpreter Console Output Channel Select (IT-12D)
Select the Console with one of the Channel Output key '1, 2, 3"; for example: If you
want this unit to be NO. 1; just press "1". Then the indicator on the key will light on
in green while the channel is not occupied. If the indicator on the key flashes in red
that means the channel is occupied by other units. When the MIC. ON/OFF of the
activated channel is at OFF state, the activate channel could be released when other
interpreter console selects the same channel number.
(2)LOCK Mode: Interpreter Console Output Channel Select (IT-12D)
Interpreter Console must be assigned with one unique output channel before being
used. The procedure is as:
a. Make sure the connection is correct, and then turn on the IT-12M4.
b. Turn the "SET" setting switch from "OFF" on the rear panel of the Interpreter
c. Assign the Console with one of the Channel Output key "1,2,3", for example: If you
d. Turn the "SET" setting switch to "OFF", the "ENTER" indicator will turn off, that
e. If cross interpretation is needed OPEN mode should be selected.
f. Repeat the same procedure (Steps b~d) to assign all the Interpreter Consoles.
(3)To Cancel Selected Output Channel (only for LOCK mode)
a. Turn the "SET" from "OFF" to "ON".
b. Push the "ENTER" for 3 seconds. Then all Channel Output Indicators will turn off.
c. Turn the "SET" from "ON" to "OFF". The Console will be of factory setting now.
Console to "ON", the indicators of "ENTER" on the unit starts flashing. The indica-
tors of available channels will turn RED. Pay attention only one channel can be
activated.
want this unit to be NO 1, just press "1". Then the indicator on the key will change
to Green light, press " ENTER " key to store, the indicator of " ENTER " will keep
light on.
means the output channel selecting procedure is completed;
13