Page 3
General Care and Safety Guide YOUR SAFETY IS IMPORTANT TO US. PLEASE ENSURE YOU TAKE NOTE OF THE INSTRUCTIONS AND WARNINGS OUTLINED IN THIS MANUAL. CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cut-out, this appliance must not be supplied through an external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the utility.
Page 4
General Care and Safety Guide • Never use the appliance to dry clothes. • Always unplug appliance when not in use. • When the appliance has been unpacked, check it for transport damage and ensure all parts have been delivered. If parts are missing or the appliance has been damaged, contact the Customer Services Team.
Page 5
General Care and Safety Guide • The appliance must not be immersed in any liquids. • There are no user serviceable parts installed in the unit. • Do not place the unit in wardrobes or other enclosed spaces as this may cause fire hazards.
Page 6
Assembly Instructions WARNING: Heater must not be used without the feet, castors, wheels fitted. This appliance has been supplied with ‘1 way screws’ for permanent installation of the feet. This is a safety requirement for the New Zealand and Australian market. Before using this appliance, it must have the castor plates with castors fitted.
Page 7
Assembly Instructions ASSEMBLY 1. Carefully turn the Main Body upside-down on a scratch-free and stable surface. Be careful to prevent damage to the cosmetic finish or your floor surfacing. 2. Align the 2 holes in the foot with the 2 holes in the base of the appliance, place screws in the centre of the holes and attach firmly with a screwdriver.
Operating Your Heater Always choose a safe location for the heater, keeping in mind the safety precautions outlined. Ensure all packaging has been removed from the unit before use. Please follow the below instructions. WARNING: In order to avoid overheating or fire, do not cover the heater. WARNING: Keep all objects at least 1 metre from the front, sides and rear of the appliance.
Page 9
Operating Your Heater Check that the heat control switch is set to Off position before plugging the appliance into the mains supply. For greater economy, use the High Heat setting initially and then switch to the Low Heat setting. HEAT CONTROL SWITCH The control switch positions are: O - Power Off I - Low Heat...
In non-domestic use Goldair limits the voluntary warranty to three months. Goldair undertake to repair or replace this product at no charge if found to be defective due to a manufacturing fault during the warranty period.
Page 12
New Zealand PO Box 100707, North Shore Mail Centre, Auckland, 0745 www.goldair.co.nz Australia PO Box 574, South Morang, Victoria, 3752 www.goldair.com.au...
Need help?
Do you have a question about the GMH211 and is the answer not in the manual?
Questions and answers