Setup; Installing The Reel Grease Fitting - Toro Reelmaster 5010 Series Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
Media and Additional Parts
Description
Operator's Manual
Parts Catalog (not included)—refer to the
included postcard for information on obtaining
the Parts Catalog
Note:
Determine the left and right sides of the
machine from the normal operating position.
1
Installing the Reel Grease
Fitting
Parts needed for this procedure:
1 Straight grease fitting
Procedure
Install the grease fitting on the reel-motor side of
the cutting unit. Refer to
position of the reel motors based on the position of the
cutting unit on the machine.
Description
Straight grease fitting
No parts required
O-ring
Cap screws (may come assembled)
Figure 3 to determine the
Qty.
1
–
1
2
Qty.
1
Review the material and save it in an appropriate place.
–
1. Cutting unit 1
2. Cutting unit 2
3. Cutting unit 3
4. Cutting unit 4
1. Remove and discard the setscrew on the
reel-motor side plate
4
Use
Install the reel grease fitting.
Adjust the cutting unit
Install the reel motors.
Use
Figure 3
5. Cutting unit 5
6. Reel motor
7. Weight or other accessory
(sold separately)
(Figure 4).
g031275