Advertisement
Please Note You may need to remove the door(s) to aid installation. This can be done by unclipping the hinges. (There is
a release catch at the back of the hinge see Fig.A). Once detached, gently extract the wire between the carcass and the
top of the door then disconnect the cable connector(s) (Ffigig.B). DO NOT FIT SHELVES AT THIS STAGE. Extra care must
be taken when handling cabinets with mirrored sides or diffusers, especially when picking up and putting down the
cabinet - do not pick up the cabinet by the diffusers.
Bracket clip (Fig A)
REAR VIEW
Mounting Points
Fixing Preparation (Fig C)
Fixing Brackets (Fig D)
Fixing Brackets (Fig F)
2
Wire connectors (Fig B)
Angle Adjustment
Claw In/Out
Claw In/Out
Adjustment
Adjustment
Hanger Adjustment (Fig E)
Wall Hung Installation
1.
Position the cabinet in a suitable location
(according to the zonal diagram (Fig 1) on the
back page) ensuring that the mains supply cable is
within reach of the cable connection point of the
cabinet. Carefully mark the desired position of the
cabinet using a soft pencil, ensuring it is level.
2. Remove the cabinet from the wall and using a spirit
level, mark a horizontal line below the pencil mark,
taking into account the location of the mounting
points (Fig. C). Place brackets on the pencil
line paying attention to the distance between
the hangers on the cabinet. Carefully mark the
position of the holes using a soft pencil. (Fig. D).
Advertisement
