Sony h.ear on 3 Wireless NC Help Manual page 91

Table of Contents

Advertisement

If no ring tone is heard via the headset
The headset may not be connected with the smartphone or mobile phone over HFP or HSP. Check the
connection status on the smartphone or mobile phone.
If playback does not pause automatically, operate the headset to pause playback.
Adjust the volume using the touch sensor control panel.
3
Increase the volume: Swipe up repeatedly until the volume reaches the desired level.
Decrease the volume: Swipe down repeatedly until the volume reaches the desired level.
To change the volume continuously: Swipe up or down and hold. Release at the desired level.
When the volume reaches the maximum or minimum, an alarm sounds.
When you finish your phone call, tap the touch sensor control panel twice quickly (with an interval of about
4
0.4 seconds) to end the call.
If you received a call during music playback, music playback resumes automatically after ending the call.
Hint
When receiving a call by operating smartphones or mobile phones, some smartphones or mobile phones receive a call with the
phone instead of the headset by default. With an HFP or HSP connection, switch the call by holding your finger to the headset's
touch sensor control panel until it switches, or by using your smartphone or mobile phone.
Volume for a call can be adjusted during a telephone conversation only.
The headset volume during a call and during music playback can be independently adjusted. Changing the call volume does not
change the volume of music playback and vice versa.
Note
Depending on the smartphone or mobile phone, when an incoming call arrives while you are listening to music, playback may not
resume automatically even if you finish the call.
Use a smartphone or mobile phone at least 50 cm (19.69 in.) away from the headset. Noise may result if the smartphone or
mobile phone is too close to the headset.
Your voice will be heard from the headset through the headset's microphone (Sidetone function). In this case, ambient sounds or
the sounds of the headset operation may be heard through the headset, but this is not a malfunction.
91

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wh-h910n

Table of Contents