Tips For Best Results - Remington Ultimate Series Quick Start Manual
Foil shaver
Hide thumbs
Also See for Ultimate Series:
- User manual (125 pages) ,
- Manual (109 pages) ,
- Quick start manual (8 pages)
Table of Contents
Advertisement
Trimming
1. Push the trimmer release button up to activate the trimmer.
2. Hold the trimmer at a right angle to your skin.
3. To retract the trimmer, slide the trimmer release button down and push the back of
the trimmer head downwards until it locks into place.
Travel lock
The travel lock prevents your shaver from accidentally switching on when it is packed in
luggage.
To set the travel lock:
•
Press and hold the on switch for 3 seconds. The shaver will turn on, then will shut off
after the 3 seconds. The LED display will flash five times to indicate the lock is set.
•
While the travel lock is set, if the on switch is pressed, the LED display will flash three
times to indicate the shaver is in travel lock mode.
TIPS FOR BEST RESULTS
•
Always hold the shaver at right angles to the skin so that all foils are touching the skin
with equal pressure.
•
Use moderate to slow stroking movements. The use of short linear motions in
stubborn areas may obtain a closer shave, especially along the neck and chin line.
•
DO NOT press hard against the skin in order to avoid damage to the foil heads.
•
Note: your shaver has been designed to be used in the shower if desired.
CARE FOR YOUR SHAVER
To ensure long lasting performance clean after each use.
1. Remove the foil assembly by pressing the release buttons on either side of the head
and lifting the foil assembly upwards to remove from the hair pocket.
2. Tap out the excess hair shavings and rinse the foils under running water.
3. Do not clean the shaving foil with a brush.
4. Replace the head assembly by placing the assembly on top of the hair pocket, press
down and click into place.
•
The easiest and most hygienic way to clean the appliance is by rinsing the appliance
head after use with warm water.
•
Lubricate the teeth of the trimmer every six months with a drop of sewing machine oil.
REPLACING THE FOILS AND CUTTERS
To ensure continued high quality performance from your shaver, we recommend the foils
and cutters are replaced every six months.
5
Advertisement
Table of Contents
