Getting Started - Remington Ultimate Series Quick Start Manual

PARTS
1. On/off switch
2. Intercept trimmer
3. Shaving foils
4. Hybrid intercept trimmer
5. Hair pocket
6. LED display
7. Charging pins (on back)

GETTING STARTED

Charge the shaver:
• Before using for the first time.
• When LO is showing.
• After your shaver has not been used for a long time.
1. Ensure the product is switched off.
2. Connect the charging stand to the adaptor and then to the mains.
3. Place the charge stand on a flat surface.
4. Place the shaver in the charge stand with the charge pins contacting.
5. Charge for at least 24 hours when using for the first time.
6. When charge is low 'Lo' will flash rapidly on the display. When charging, the LED's
flash in a clockwise rotation.
7. When fully charged the display will flash 60 for 1 minute and then turn off.
• To preserve the life of your batteries, let them run out every 6 months then recharge
for 24 hours.
• The appliance adapts automatically to mains voltages between 100V and 240V.
Quick charge
• Your shaver is fitted with a 5 minute quick charge feature that will provide enough
charge for 1 shave (3 minutes).
INSTRUCTIONS FOR USE
It is recommended that you use your new shaver daily for up to four weeks to allow time
for your beard and skin to become accustomed to the new shaving system.
Shaving
1. Switch the shaver on by pressing the on/off switch.
2. Stretch the skin with your free hand so the hairs stand upright.
3. Hold the shaving head so that the foils touch your face.
4. Use short, linear strokes.
4
8. Pop-up trimmer (on back)
9. Charging stand
10. Foil assembly release buttons
11. Adaptor (not shown)
12. Head guard (not shown)
13. Storage case (not shown)