Emptying The Dirt Tank; Removing The Brush Roll - Bissell ICONPET 2288 Series Manual

Emptying the Dirt Tank

More of a video person? Go to support.BISSELL.com for additional how-to videos.
1.
Turn OFF your machine.
Remove the Dirt Tank from the
hand vacuum by sliding the
latch on the front of the tank.
4.
Dump dirt from the tank
into the trash bin.

Removing the Brush Roll

Go to support.BISSELL.com for a full list of maintenance and troubleshooting support.
1.
Turn the machine OFF and
press the Foot Release Button
to disconnect the Motorized
Floor Cleaning Foot from the
Extension Wand.
WARNING
» Before using your vacuum, make sure that the Dirt Tank is in locked position and that all filters, both pre and post-filters, are in
place. DO NOT operate your vacuum without these filters.
2.
Grab the top of the tank
and pull up. This will activate a
wiping feature to remove debris
from the mesh filter screen.
5.
Slide the separator back
into the tank, ensuring the
notch is seated into the tank
correctly.
2.
With a flathead screwdriver
or coin, twist the slot on the
side of the foot clockwise and
pull the Brush Roll out.
3.
Fully remove the separator
from the tank and tap the
mesh screen on the side of the
trash bin.
2
1
6.
Put the whole tank into
the hand vacuum by guiding
the notched out area on the
bottom of the tank onto the
hook on the hand vacuum.
Push into place.
3.
To replace, push the Brush
Roll back in the chamber and
twist counter-clockwise with a
tool or coin to lock in place.
BISSELL.com 9