Checking And Changing The Settings; Setting A Duration; Setting A Delayed Start / End Time - V-ZUG Combair SL Operating Instructions Manual

5 Using the appliance
Display overview
3
2
1
5.2

Checking and changing the settings

▸ Select the symbol for the desired setting.
▸ To change the value, turn the adjusting knob to the right or left.
▸ Press the adjusting knob to confirm the setting.
– The operating mode settings are displayed.
– The changed value can be seen above the corresponding symbol.
The end time can only be changed during the first 60 seconds of
operation.
5.3

Setting a duration

The operating mode selected ends automatically when the operating time is up.
▸ Select the desired operating mode.
▸ Select in the operating mode settings.
▸ Set the desired duration – max. 9 hours and 59 minutes – and confirm.
– The duration is displayed in the operating mode settings as well as the end time
which is calculated based on this value.
– End of operation / duration finished (see page 23)
5.4

Setting a delayed start / end time

The delayed start is activated when for the operating mode selected both the duration
and the end time are set.
The appliance switches automatically on and off again at the desired times.
If you use the food probe, you will need to estimate and set the duration. You will find a
guide on times in «EasyCook». The appliance switches on with a delay and switches off
again when the set target temperature is reached. Depending on the estimated duration,
this can occur earlier or later than the set end time.
Perishables should not be kept unrefrigerated.
Before setting the delayed start
▸ Place the food in the cooking space.
▸ Select the desired operating mode.
▸ Set the temperature.
▸ Set the duration.
Setting a delayed start
▸ Select in the operating mode settings.
– The current end time calculated using the duration is displayed.
18
4 1 Operating mode settings
2 Current position of the adjusting knob /
selected setting
3 Press and go
5
4 Operating mode with symbol
6
5 Set values / recommended values
6 Symbols for settings