Fortinet FortiController FortiController-5208 System Manual page 8

Backplane gigabit interfaces
Backplane gigabit interfaces
8
Table 2: FortiController-5208 connectors (Continued)
Connector Type Speed
1, 2, 3, 4 LC SFP 1000 Mbps Ethernet
D15, D16 LC SFP 1000 Mbps Ethernet
C15, C16 LC SFP
COM1, COM2 RJ-45 9600 bps
MANAGEMENT RJ-45 1000 Mbps Ethernet
The FortiController-5208 module uses the chassis backplane gigabit interfaces for
all communication with modules installed in the chassis. This communication
includes:
• Management communication between the primary FortiController-5208, the
optional secondary FortiController-5208, and the FortiGate-5005FA2 modules.
• Delivery of traffic data to the FortiGate-5005FA2 modules for processing.
• Receiving processed traffic from the FortiGate-5005FA2 modules.
• If installed, the secondary FortiController-5208 module also delivers data traffic
to the FortiGate-5005FA2 modules and receives the processed traffic from
them.
No front panel cables are required for connections between the installed modules.
Once the FortiController-5208 module is configured as the primary, and the
FortiGate-5005FA2 modules are configured to use the LDB firmware, all
communication between the installed modules is automatic and requires no
configuration.
FortiController-5208 module
Protocol Description
Four 1 gigabit SFP interfaces that can
accept fiber or copper transceivers.
These interfaces operate only at
1000Mbps. See "Installing XFP and
SFP transceivers" on page 9
information.
Two 1 gigabit SFP interfaces used for
inter-chassis high-availability (HA)
connections.
For future use.
RS-232 Serial connection to the command line
serial interface.
Ethernet management connection to
the FortiController-5208 web-based
manager and command line interface.
FortiController-5208 System Guide
01-30000-0376-20070615
for more