Table of Contents
Advertisement
Indesit
Company
JOINING KIT - 'J' MODELS ONLY
Freezer Supplied ~ LH door hinging – Fridge Supplied ~ RH door hinging
Before attempting to join the two appliances together, it is important to level each appliance
separately in the position it will stand. If this is not done properly it will be more difficult to join the
appliances together and undue stresses may be introduced into the cabinets over time.
The adjustable feet are located at the front but there is nothing at the rear.
Where a floor is really uneven, it could necessitate the use of suitably sized packing material, such as
wood or hardboard under the rear to ensure the appliance is supported adequately.
The items supplied in the joining kit are:
1 x Bracket (Cabinet join, control panels) - 1 x Bracket (Cabinet join, Plinths) - 1 x Tapping Plate &
1 x Fixing Plate - 2 x Brackets (Cabinet rear) - 2 x Blanking Plates (Control Panels) - 1 x Filler Trim
(Cabinet front) - Fixing Screws.
1. Remove the control panel blanking plates from the freezer right hand side and fridge left hand
side. See image below.
2. Attach the cabinet control panel bracket using the screws provided. See image below.
3. Remove the base moulding blanking plates from the freezer right hand side and fridge left hand
side. See image below.
Service Manual UK
12 of 16
English
Advertisement
Table of Contents
