Anynet+ (Hdmi-Cec) Isn't Working - Samsung NU7090 series E-Manual

Anynet+ (HDMI-CEC) Isn't Working

When Anynet+ (HDMI-CEC) isn't working, these steps may help resolve the problem.
The problem
Anynet+ does not work.
I want to start Anynet+.
I want to exit Anynet+.
The message "Connecting
to Anynet+ device..." or
"Disconnecting from
Anynet+ device" appears
on the screen.
The Anynet+ device won't
play.
The connected device is
not displayed.
The TV audio is not being
played through the AV
receiver.
Confirm that the device is an Anynet+ device. The Anynet+ system supports Anynet+ devices
only.
Check if the power cord of the Anynet+ device is properly connected.
Check the cable connections of the Anynet+ device.
Go to Anynet+ (HDMI-CEC)
● Settings
Anynet+ may not function when some other functions are active, including Channel Search,
Smart Hub, Initial Setup, etc.
If you have disconnected and then reconnected the HDMI cable, scan for devices again or turn
your TV off and on.
Move the focus to the Anynet+ device at
button to move to Anynet+, and then press the Select button.
Check if the Anynet+ device is properly connected to the TV, and then select
CEC) menu to see if Anynet+ (HDMI-CEC)
● Settings
Set Anynet+ (HDMI-CEC) to Off.
●
Settings
You cannot use the remote control when the TV is configuring Anynet+ or switching to a
viewing mode.
Use the remote control after the TV has completed the Anynet+ configuration or has switched
to a viewing mode.
You cannot use the play function when
Check whether the device supports Anynet+.
Anynet+ devices must be connected to the TV using an HDMI cable. Make sure the device is
connected to your TV with an HDMI cable. Some HDMI cables may not support Anynet+.
Check whether the HDMI cable is properly connected.
Go to Anynet+ (HDMI-CEC)
●
Settings
Scan for Anynet+ devices again.
If the connection is terminated because there has been a power failure or the HDMI cable has
been disconnected, please scan for the device again.
Make sure that the AV receiver is connected to the TV's HDMI (ARC) port with an HDMI cable.
Confirm that the AV receiver is HDMI (ARC) compatible.
If the AV receiver is not HDMI (ARC) compatible, connect the TV and the AV receiver with an
optical cable.
Try this!
and see if Anynet+ (HDMI-CEC)
General External Device Manager
is set to On.
General External Device Manager
General External Device Manager
Start Setup is in progress.
and see if Anynet+ (HDMI-CEC)
General External Device Manager
- 118 -
has been set to On.
Anynet+ (HDMI-CEC)
Source, and then press the up directional
Anynet+ (HDMI-
Anynet+ (HDMI-CEC)
Anynet+ (HDMI-CEC)
has been set to On.
Anynet+ (HDMI-CEC)