Anynet+ (Hdmi-Cec) Isn't Working - Samsung un55j6500AK E-Manual

Anynet+ (HDMI-CEC) Isn't Working

The problem
Anynet+ does not
work.
I want to start
Anynet+.
I want to exit Anynet+.
The message
"Connecting to
Anynet+ device..."
or "Disconnecting
from Anynet+ device"
appears on the screen.
The Anynet+ device
won't play.
The connected device
is not displayed.
The TV audio is not
being played through
the receiver.
Confirm that the device is an Anynet+ device. The Anynet+ system supports
Anynet+ devices only.
Check if the power cord of the Anynet+ device is properly connected.
Check the cable connections of the Anynet+ device.
Go to System and see if
Check whether the TV remote control is in TV mode.
Check whether the remote control is Anynet+ compatible.
Anynet+ may not function when some other functions are active, including Channel
Search, Smart Hub, Plug & Play, etc.
If you have disconnected and then reconnected the HDMI cable, scan for devices
again or turn your TV off and on.
Check if the Anynet+ device is properly connected to the TV, and then select the
System menu to see if
Select View TV from the Anynet+ menu.
Select a non-Anynet+ device from the Source list.
You cannot use the remote control when you are configuring Anynet+ or switching
to a viewing mode. Use the remote control after the TV has completed the Anynet+
configuration or has switched to a viewing mode.
You cannot use the play function when
Check whether the device supports Anynet+.
Check whether the HDMI cable is properly connected.
Go to System and see if
Scan for Anynet+ devices again.
Anynet+ devices must be connected to the TV using an HDMI cable. Make sure the
device is connected to your TV with an HDMI cable. Some HDMI cables may not
support Anynet+.
If the connection is terminated because there has been a power failure or the HDMI
cable has been disconnected, please scan for the device again.
Connect an optical cable to the TV and the receiver.
ARC enables the TV to output digital sound via the HDMI (ARC) port.
However, ARC is only available when the TV is connected to an audio receiver that
supports ARC.
Try this!
Anynet+ (HDMI-CEC)
Anynet+ (HDMI-CEC)
Setup
Anynet+ (HDMI-CEC)
has been set to On.
is set to On.
is in progress.
has been set to On.