Table of Contents
Advertisement
PAGE 22
GPI Cable
A special cable is required. You can buy a Thumbs Up-to-TitleMaker GPI
trigger cable from Videonics (part number CBLA-0034-01) or you can buy or
make your own. The cable has a stereo male 3.5 mm sub-mini-plug at each
end and three wires connect each terminal of one plug to the corresponding
terminal of the other.
For other controllers, you will have to make your own cable using a stereo
male 3.5 mm sub-mini-plug at one end. Wire the "tip" and "base" (not the
middle "ring") to the two wires of your GPI trigger source.
You can also wire a pushbutton switch to the GPI input to remotely trigger
titles, as described in Chapter 20.
VIDEONICS TITLEMAKER 2000
Advertisement
Table of Contents
