Table of Contents
Advertisement
VIDEONICS TITLEMAKER 2000
• To assure reliable storage of titles, always press POWER and be sure the
power light is out before you unplug the power supply.
Here's why: Titles are retained by the built-in lithium battery when you
turn the power off. Even when the unit is unplugged, all titles remain
intact, including all settings and formatting. When you turn the unit off,
the TitleMaker 2000 reorganizes its memory to optimize storage. It is
important not to unplug the unit until the light turns off, telling you this
operation is complete.
Connecting Outputs and Monitors
AUDIO
VIDEO
IN
IN
OUT
R
L
V
OUT
R
L
Connect the OUTPUT monitor to the TitleMaker 2000's video OUT jacks:
• 1A, 1B: If you will be recording the output (as in a video production
setup), connect the TitleMaker 2000 video OUT to the VIDEO IN of the
Record VCR. Then connect a television or monitor to the Record VCR, as
described in the manual that came with the VCR.
You can use either S-video (Y/C) cables (1A) or composite (RCA-style)
cables (1B) to connect the TitleMaker 2000 to the VCR. You can use S-
video, composite, or RF (cable/antenna) cables to connect the VCR and the
television/monitor.
In either case, connect the TitleMaker 2000 audio OUT jacks (marked L
and R) to the Record VCR's AUDIO IN.
• 2: If you will not be recording the output, connect the TitleMaker 2000
video OUT to the VIDEO IN of a monitor. You can use S-video (Y/C) or
composite (RCA-style) cables for this connection. If you are using a televi-
sion with no VIDEO input (that is, it has only an RF (cable/antenna) jack,
you will need a VCR or an "RF modulator" to connect the TitleMaker 2000
to it.
Connect the TitleMaker 2000 audio OUT (marked L and R) to the monitor's
1A
S
V
Example Output Connections
AUDIO
VIDEO
IN
IN
1B
OUT
R
L
V
S
OUT
R
L
V
PAGE 15
AUDIO
VIDEO
IN
IN
2
OUT
R
L
V
S
OUT
R
L
V
Advertisement
Table of Contents
