Drive System Maintenance; Adjusting The Tracking - Toro Z Master Professional 7000 Series Operator's Manual

Figure 63
1. Ignition—30 A (F1)
2. Radiator fan—50 A (large,
heavy duty fuse)
g012492
3. Clutch—10 A (F3)
4. Left fuel tank
Drive System
Maintenance

Adjusting the Tracking

The machine has a knob for adjusting the tracking
located under the seat.
Important:
Adjust the handle neutral and
hydraulic pump neutral before adjusting the
tracking; refer to Adjusting the Control Handle
Neutral Position (page 60)
Hydraulic Pump Neutral Position (page
1. Push both control levers forward the same
distance.
2. Check if the machine pulls to 1 side. If it does,
shut off the machine and engage the parking
brake.
3. Unlatch the seat and tilt the seat forward to
access the tracking knob.
Note:
Determine the left and right sides of the
machine from the normal operating position.
4. To make the machine go right, turn the knob
toward the right of the machine; refer to
64.
5. To make the machine go left, turn the knob
toward the left of the machine; refer to
6. Repeat adjustment until the tracking is correct.
49
and Setting the
65).
Figure
Figure 64.