Safety Instructions & Precautions - Crown Royal Stoves RS7300E Owner's Manual

SAFETY INSTRUCTIONS & PRECAUTIONS
• All installation and operations must follow federal, provincial, state, and local codes for wire plumbing,
and installing chimney.
• All work must be performed by qualified personal only.
• Read and understand all precautions before operating the furnace.
• Furnace not to be used as a stand alone unit. It is recommended that a back up system be in place.
• Retain this manual as long as you own your Crown Royal Stove. Carefully read and follow these
directions. Regularly read over this manual to keep you informed.
DANGER!!! Do not start fire with chemicals, volatile fluids, rubber, plastics or garbage. Some processed wood
contain resins and should be avoided. Only competent persons with a sound understanding of this heating
method should operate this furnace. Improper firing could result in personal injury and/or damage to unit, and
void warranty. Do not burn garbage, gasoline, drain oil, naphtha, engine oil, railroad ties, particle board,
leaves, cardboard, or any other flammable liquids.
WARNINGS!!
• All installations and operations of your
furnace must follow STATE, PROVINCIAL
and LOCAL LAWS pertaining to operations,
wiring, plumbing, and building codes. The
installation must be performed by a qualified
installer.
• Only burn wood as the primary fuels in this
unit. (Check with provincial, state, and local
regulations that obtain to banned fuels in
designated locations)
• Only use wood with less then 30% moisture
content.
• Do not install this unit on a combustible
surface.
• All models operate at atmospheric pressure.
DO NOT obstruct, block or plug the overflow
vent tube in any way, which is located on top
of the furnace.
• You must open the chimney flue before
opening the furnace door.
• This unit can not be hooked to a chimney
already serving another appliance. When
installing a chimney that is higher than
twelve feet, guide lines must be used.
• This unit must never be pressurized.
• Do not use an automatic stoker with this unit.
• Risk of Fire: Do not operate with fuel
loading, heat exchanger door or secondary
combustion door open. Do not store fuel or
other combustible materials within marked
installation clearances. Inspect and clean
flues and chimney regularly.
CAUTIONS!!!
• Hot Surfaces: Keep children away. Do not
touch during operation.
• Do not start or operate furnace without
checking heating fluid.
• Check for buried cables and utility lines
before digging trench.
• For safety and proper temperature control,
keep fuel door closed tightly during operation.
• Do not fire up boiler until filled with water.
• Do not to start the unit during a prolonged
power failure.
• Load fuel carefully to avoid injury to hands,
fingers and other body parts that may
come in contact with the unit's loading door
opening.
• Cleaning of the heat exchanger, flue pipe,
chimney and draft inducer if used, is
especially important at the end of the heating
season to minimize corrosion during the
summer months caused by accumulated ash.
• When installing the heat exchanger, be sure
none of the existing system safety controls
are disabled.
• When installing heat exchangers do not
tamper with existing controls. Wiring to
existing blower can be done with a line
voltage or low voltage thermostat.
• Do not open secondary combustion door
while in operation, Doing so will result in fire
hazard and/or severe burns.
• Always check for adequate water levels.
12