Using The Smart Speed Tm Control System - Toro TimeCutter HD X5450 Operator's Manual

Driving Backward
1. Move the levers to the center, unlocked position.
2. To go backward, slowly pull the motion-control levers
rearward (Figure 23).
Figure 23
G008953
g008953
20
Using the Smart Speed
Control System
The Smart Speed TM Control-System lever, located below the
operating position (Figure
to drive the machine at 3 ground speed ranges—trim, tow,
and mow.
Figure 24
1. Smart-speed lever
To change speeds, do the following:
1. Move the motion-control levers to neutral and outward
to the N -L
EUTRAL OCK
2. Disengage the blade-control switch.
3. Adjust the lever to the desired position.
The following are only recommendations for use.
Adjustments vary by grass type, moisture content, and the
height of the grass.
Trim
Suggested
uses:
Parking X
Heavy, wet X
grass
Training X
Bagging
Mulching
Normal
mowing
Transport
Trim
This is the lowest speed. The suggested uses for this speed
are as follows:
•
Parking
•
Heavy, wet grass mowing conditions
•
Training
Tow
TM
24), gives the operator a choice
position.
Tow Mow
X
X
X
X
g027625