Advertisement
Programming Rolling Code Garage Door Opener or Device
1. Firmly PRESS the outer two Lear UGDO™ buttons for one — two seconds and
immediately release them.
2. Go to the garage. Locate the garage door motor head and Press and Release its "learn"
button. You may need a ladder to reach the unit and you may need to remove the unit's
cover to locate the "learn" button. After pressing the "learn" Button you have 10 to 30
seconds to complete Step 3 depending on your garage control unit If you cannot locate
the "learn" button, refer to the Owner's Guide of your garage door opener or call 1-866-
57Car2U.
3. Return to your vehicle, Press and HOLD the Car2U Button you would like to use to
control the garage door. Immediately
door begins to move. You may need to hold the button from 5 to 20 seconds during
which time the selected button indicator light will blink slowly.
Lear UGDO Owner's Guide Version 3.2 Page 4
Short Term Confidentiality Requested
Lear UGDO
(within 1 second)
release the button once the garage
"Learn" Button shown
on typical Rolling Code
Garage Door Opener
Press ANY one of the three
Lear UGDO™ buttons to
assign the rolling code to the
garage door opener.
3/27/2006
Advertisement
