Removing The Ccd - Clevo N870HK1 Service Manual

Removing the CCD

1. Turn off the computer, turn it over to remove the battery
2. Lay the computer down on a flat surface with the top case up forming a 90 degree angle. Carefully remove the
rubber covers - and screws
1 2
3. Run your fingers around the inner frame of the LCD panel to lift at the upper point
and slightly push and lift up the inner frame at the middle points
your fingers around the inner frame at the lower point
4. Remove the LCD front cover
a.
3
1
b.
(page 2 -
- .
3 4
as indicated by the arrows
8
(Figure 7b).
5
2
4
9
5).
as indicated by the arrows,
5
- as indicated by the arrows and then run
6 7
(Figure 7a).
8
6 7
5
Disassembly
Figure 7
CCD Removal
a. Remove rubber and
screws and then careful-
ly release the inner
frame of the LCD panel
at the points indicated by
the arrows.
b. Remove the LCD front
cover.

9. LCD Front Cover
• 2 Screws
Removing the CCD 2 - 13