Removing The Hard Disk Drive - Clevo N870HK1 Service Manual

Removing the Hard Disk Drive

The hard disk drive can be taken out to accommodate other 2.5" serial (SATA) hard disk drives with a height of 7mm
(h). Follow your operating system's installation instructions, and install all necessary drivers and utilities (as outlined in
Chapter 4 of the User's Manual) when setting up a new hard disk.
Hard Disk Disassembly Process
1. Turn off the computer, and remove the battery
2. Remove the SD card cover
3. Carefully push to release the bottom case
case and ports as indicated by the arrows
4. The HDD will be visible at point
a.
4
2
14
3
15
13
12
11
10
c.
21
(page 2 - 5).
and screws - (Figure 2a).
1 6 2 17
from point and then lift it up from point
18 19
)
(Figure 2b .
on the mainboard (Figure 2c
21
b.
5 6
16
7
17
1
9
8
18
to release the bottom
20
)
.
19
18
Removing the Hard Disk Drive 2 - 7
Disassembly
Figure 2
HDD Assembly
Removal
a. Remove the SD card
cover and screws.
b. Remove the bottom
case.
c. Locate the HDD.
20

18. Bottom Case
• 16 Screws