Programming The Water Volume; Settings Mode: Reset To Factory Settings - Nespresso BREVILLE EXPERT&MILK Manual

Programming the water volume

Settings mode: Reset to Factory Settings

If you reset to factory settings, this will cancel the pairing and
capsule stock management and reset the water hardness level.
Factory settings are:
1. Ristretto (25 ml / 0.84 oz), Espresso (40 ml / 1.35 oz), Lungo (110 ml / 3.7 oz),
Americano (25 ml / 0.84 oz coffee; 125 ml / 4.2 oz hot water). Or select the drop icon for
hot water (200 ml / 6.7 oz).
2. Automatic OFF mode after 9 minutes.
3. The water hardness set by default is hard.
4. No device paired.
10119_UM_EXPERT&MILK_BREVILLE.indb 17
Any coffee button can be programmed:
Ristretto: from 15 to 30 ml / 0.5 to 1 oz
Espresso: from 30 to 70 ml / 1 to 2.33 oz
Lungo: from 70 to 130 ml / 2.33 to 3 oz
Americano: coffee from 15 to 110 ml / 0.5 to 3.7 oz,
hot water from 25 to 300 ml / 0.84 to 10.1 oz
Hot water from 50 to 300 ml / 1.7 to10.1 oz
To program Ristretto, Espresso and Lungo volumes:
1. Ensure the machine is ON. 2. Open the slider and insert the capsule.
3. Close the slider. 4. Select desired coffee and press and hold brewing
button. 5. Release the button when desired volume is reached. 6. Brewing
button will flash 3 times for confirmation.
To program Americano volume:
1. Select Americano recipe and press and hold brewing button until desired
coffee volume is reached. 2. Press and hold again and keep pressed until
desired water volume is reached. 3. Brewing button will flash once for
confirmation. 4. Water and coffee volume are now stored.
To program water volume:
1. Select hot water icon and press and hold brewing button until desired
water volume is reached. 2. Water volume is now stored.
To do it via your machine:
- Ensure machine is OFF and slider is closed.
- Press brewing button for 6 seconds - both dials will flash to confirm you are in settings mode.
- Select Lungo cup and press brewing button.
- The Lungo cup will blink to confirm you have entered this mode.
- To exit this mode without doing a factory reset, push the brewing button.
No / Exit: Yes / Confirm:
- To factory reset, turn temperature dial up to maximum position and press brewing button.
- All lights will blink to confirm.
EN
17
19.08.16 12:38