Table of Contents
Advertisement
9.2.4.
Slide Cam
1. Perform the step "9.2.3. Pulley Gear, Belt".
2. Remove the Sheet.
3. Disconnect the 3 FFCs.
4. Remove the 2 Screws (B) and the Angle.
5. Peel off Coppery Sheet from FFC (A) and remove the
Drive P.C.B.
Caution:
Though the Drive P.C.B. is not supplied as replace-
ment parts, it must be removed for after disassem-
bling.
6. Open the connector lock, and disconnect the FFC.
7. Remove the 2 Screws (C), and remove the Traverse
Base Ass'y with spreading the 2 hooks to the direction of
arrows.
8. Remove the Slide Cam.
9.2.5.
Mid Gear, Drive Gear and Loading
Motor
1. Perform the step "9.2.4. Slide Cam".
2. Remove the Mid Gear and Drive Gear.
3. Remove the Screw (D) to remove the Loading Motor.
4. Remove the Screw (E), and remove the SW P.C.B. with
the Loading Motor.
Remove the 2 soldering points, and remove the Loading
Motor.
26
Advertisement
Table of Contents
