Table of Contents
Advertisement
OPERATIONAL INSTRUCTIONS
Amplifier and Radio Operation - continued
Headphones jack
The headphones PHONES jack (10) is for headphones with a 30- to 600-Ohm impedance, and
equipped with a 3.5mm jack. Use an adapter (sold in electronic outlets) if your headphone has a
different plug. The speakers are automatically switched off when the headphones are being used.
CAUTION
Listening at high volumes for an extended period of time may cause
damage to the users hearing.
AM/FM radio operation
1. Turn the unit on by pressing
the POWER button (1)/(34).
2. Switch to the Tuner operating
mode by pressing the button
TUNER/BAND (23)/(56).
Manual station selection
1. Press button TUNER/BAND (23)/(56) repeatedly until the desired frequency band appears.
2. Press the buttons TUNING – or TUNING + (12)/(46) or (7)/(44) to tune to the desired radio
stations and have them indicated in the display (3).
3. Briefly tapping the TUNING – or TUNING + button step by step alters the reception frequency
upward or downward.
Station search operation
1. Holding down one of the two buttons TUNING – or TUNING + (12)/(46) or (7)/(44) for approx. 1 second
starts the search operation and determines the direction of the search. The search operation
simply finds stations with strong signals. Stations with weak reception can only be tuned
in manually.
2. Hold the TUNING – or TUNING + button to start the station search again. During the search
operation, the tuner is muted.
15 | iLuv
OPERATIONAL INSTRUCTIONS
Amplifier and Radio Operation - continued
Stereo / Mono
Repeatedly pressing the button
ST. / MONO (11) switches between
stereo and mono reception.
The stereo reception of a station
in the FM band is indicated
on the display (3)
In the case of stereo stations with a bad (noisy) reception, we recommend switching tuner to mono
reception. Press the ST. / MONO button. In the display (3), the message STEREO will disappear in
mono mode.
Tuner preset station
Each time the MEM./CLK ADJ. button (22)/(53) is pressed, the memory positions are called up one
after another in ascending number order.
The memory positions are selected directly using the numerical keys 1 - 0 / +10 (35) on the
remote control.
1. Program sites 1 – 9:
Press the corresponding key 1- 9.
2. Program sites 10 – 19: Press button +10 and then the appropriate button 0 - 9.
3. Program site 20:
Press button +10 twice and then the button 0.
Programming AM and FM stations in memory
The program memory allows you store 32 stations in FM and AM range. Program place selection is
described in the previous operating section.
1. In TUNER mode, select FM or
AM reception
2. Seek out the station required by
"Manual station selection" or
"Station search operation"
3. Press the MEM./CLK ADJ. (22)/(53)
and then press the REPEAT/PRESET
(8, front panel) or REPEAT/PRESET
(36, remote) until the desired memory preset appears.
i9300 | V10M10_IM_EN_11112008
iLuv | 16
Advertisement
Table of Contents
