Changing A Program Position; Digital Clock And Timer; Setting The Digital Clock; Setting The Timer - Iluv i9300 Instruction Manual

OPERATIONAL INSTRUCTIONS
Amplifier and Radio Operation - continued
4. Press the MEM./CLK ADJ. button
again to store the station along
with its preset. Repeat as required.
Note: You can also directly select the desired program preset by pressing numeric buttons 0~9 /
+10 (35) on the remote control. Store any remaining stations by repeating the process.

Changing a program position

If a memory position needs to be replaced by a station other than the current one, the new station
can be programmed as described above, and this will automatically replace the original station.
17 | iLuv
OPERATIONAL INSTRUCTIONS

Digital Clock and Timer

Setting the digital clock

When you first plug in the unit,
the display shows:
Note:
To set the clock to the current time,
proceed as follows:
1. Press MEM./CLK ADJ. and the hour
will begin to flash.
2. Enter the hour by pressing the
TUNING + SKIP/SEARCH
buttons
or TUNING - SKIP/SEARCH.
3. Confirm the hour entry by pressing
MEM./CLK ADJ. The minutes will then
begin to flash.
4. Enter the minutes by pressing the buttons
– SKIP/SEARCH and confirm with MEM./CLK ADJ.
To switch to the clock display while in tuner and CD modes, press DISPLAY MODE. The time is
displayed for approximately 5 seconds. The time is also displayed when the unit is turned off.

Setting the timer

You can set automatic switch-on and switch-off times with the built-in timer. Before you do this, be
sure the clock is set correctly.
1. With the unit on, press DISPLAY MODE
(9)/(42), as required, until TIMER ON
appears in the display.
2. Press MEM./CLK ADJ. (22)/(53) and
the hour will begin to flash. Use the
TUNING + SKIP/SEARCH or
TUNING - SKIP/SEARCH to set
the hour of the desired switch-on time.
i9300 | V10M10_IM_EN_11112008
EU Only
EU Only
TUNING + SKIP/SEARCH or TUNING
EU Only
iLuv | 18