Table of Contents
Advertisement
OPERATIONAL INSTRUCTIONS
Basic Operation with iPod
Installing the dock adapter
Before docking your iPod on i9300/i9300D, a dock adapter must be properly installed. Please make
sure you are using a correct dock adapter for your iPod and that it is properly inserted into the
universal wall of i9300/i9300D. Failure to do so may damage your iPod.
Playing the iPod
1. Insert the already playing iPod in the universal dock.
2. Press the iPod PLAY/PAUSE
button. The display will
show "Detect iPod State" and an "iPod" icon. At the same
time, i9300/i9300D will automatically turn on, and you will
hear the music playing from your iPod.
3. Press the iPod SKIP
or
button (51) or (39) to
select desired track.
Pause / stop
To briefly interrupt playback, press the
iPod PLAY/PAUSE
button (21)/(50). The display will
show "PLAY/PAUSE SET" for a second then back to
normal mode.
1. Press iPod PLAY / PAUSE
button again to restart play.
2. To end the iPod playback, select CD or TUNER mode,
or press the POWER button to off.
Charging your iPod
To charge your iPod, insert your iPod into the built-in universal dock. Ensure that i9300/i9300D is
connected to an outlet.
29 | iLuv
CARE AND MAINTENANCE GUIDE
· Treat the disc carefully. Handle the disc only by its edges. Never allow your fingers to contact with
the shiny, unprinted side of the disc
· Do not attach adhesive tape, stickers etc., to the disc label
· Clean the disc periodically with soft, lint-free, dry cloth. Never use detergents or adhesive
cleaners to clean the disc. If necessary, use a CD cleaning kit
· If disc skips or gets stuck on a section of the disc, it is probably dirty or damaged (scratched)
Install iPod
· When cleaning the disc, wipe in straight lines from the centre of the disc to the edge of the disc.
Never wipe in circular motions.
· To remove a disc from its storage case, press down on the centre of the case and lift the disc outs,
holding it carefully by the edges
· Fingerprints and dust should be carefully wiped off the disc's recorded surface with a soft cloth.
Unlike conventional records. compact disc have no groove to collect dust and microscopic debris,
so gently wiping with a soft cloth should remove most particles.
CLEANING THE UNIT
· To prevent fire or shock hazard, disconnect your unit from the AC power source when cleaning
· The finish on the unit may be cleaned with a dust cloth and cared for as other furniture, Use
caution when cleaning and wiping the plastic parts
· If the cabinets become dusty wipe them with a soft dry dust cloth. Do not use any wax or polish
sprays on the cabinets
· If the front panel becomes dirty or smudged with fingerprints it may be cleaned with a soft cloth
slightly dampened with a mild soap and water solution. Never use abrasive cloths or polishes as
these will damage the finish of your unit
CAUTION
i9300 | V10M10_IM_EN_11112008
never allow any water or other liquids to get inside the unit
while cleaning.
iLuv | 30
Advertisement
Table of Contents
