Title Introduction; Programming Memory; Id3 Tag (Artist/Title) - Iluv i9300 Instruction Manual

OPERATIONAL INSTRUCTIONS
MP3 Disc Operation - continued
2. Press the REPEAT button again to have the entire MP3 disc
played continuously.
3. Press the REPEAT button a third time to have all the inserted MP3 discs
played continuously.

Title introduction

1. Press the INTRO button (14) during stop mode to playback the first 10 seconds of each title.
2. Press the INTRO button again and the CD player plays will play the currently selected track.

Programming memory

The built-in program memory enables up to 40 titles to be played from up to 4 CDs in the order of
your choice. Any title can be stored more than once within one program.
1. Insert a CD in its compartment.
2. By pressing the button MEM./CLK ADJ. (22)/(53) in the stop mode you
can switch to the programming mode.
27 | iLuv
OPERATIONAL INSTRUCTIONS
MP3 Disc Operation - continued
3. Select the desired title using the numeric buttons 0 - 9 / +10 (35) on the remote
control device or by repeatedly pressing
4. Press the MEM./CLK ADJ. (20)/(53) to save the title on the first program
location. In display unit (3) appears:
5. Confirm selection using the MEM./CLK ADJ. button (22)/(53).
6. To store the remaining titles in the memory, repeat Steps 3-5.
PLAY/PAUSE button (13)/(41). When
To play back the program, press the
pressed, the program can be played back again as long as MEMORY appears on the display unit (3).
To Clear the Program (Resume Normal Playback)
The programming is erased by pressing the
(until the MEMORY display disappears), or by opening the disc compartment.
Note: RANDOM button is not used for programming.

ID3 TAG (Artist/Title)

1. When an MP3 disc is playing, press the MP3 MODE button repeatedly. The track no., title and
artist information will be shown in the display if disc information is available.
2. To resume normal play display, press the MP3 MODE button repeatedly until playing
time reappears.
i9300 | V10M10_IM_EN_11112008
TUNING + or TUNING –.
PLAY/PAUSE is
STOP button (11)/(48) in the programming mode
iLuv | 28