Unlatching The Seat; Pushing The Machine By Hand - Toro 74269TE Operator's Manual

Figure 28
1. Back rest knob

Unlatching the Seat

Push the seat latch rearward to unlatch the seat.
This will allow access to the machine under the
seat (Figure 29).
Figure 29
1. Seat latch
2. Fuel cap
2. Right-side arm rest
3. Seat
Pushing the Machine by
Hand
Important: Always push the machine
by hand. Never tow the machine because
hydraulic damage may occur.
Pushing the Machine
1. Disengage the power take off (PTO) and
turn the ignition key to off. Move the levers
to neutral locked position and apply parking
brake. Remove the key.
2. Rotate the by-pass valves counterclockwise
1 turn to push. This allows hydraulic fluid to
by-pass the pump enabling the wheels to turn
(Figure 30).
Important: Do not rotate by-pass valves
more than 1 turn. This prevents valves
from coming out of the body and causing
fluid to run out.
3. Disengage parking brake before pushing.
Changing to Machine Operation
Rotate the by-pass valves clockwise 1 turn to
operate machine (Figure 30).
Note: Do not over tighten the by-pass valves.
The machine will not drive unless by-pass valves
are turned in.
Figure 30
1. Side console controls
2. By-pass valve
29
3. Hydraulic pumps