Table of Contents
Advertisement
height) at the front and rear of the steering
tires. Front measurement must be 3mm less
than the rear measurement.
1
Figure 54
1. Tie rod
2.
To adjust, loosen the clamps at both ends of the
tie rod.
3.
Rotate tie rod(s) to move the front of the tire
inward or outward.
4.
Tighten the tie rod clamps when adjustment is
correct.
Maintenance
Battery Care
IMPORTANT: Before welding on the machine,
disconnect both cables from the battery,
disconnect both wire harness plugs from the
electronic control unit and the terminal
connector from the alternator to prevent damage
to the electrical system.
Wear safety goggles and rubber gloves when
working with electrolyte. Charge the battery in a
well ventilated so gases produced while charging
can dissipate. Since the gases are explosive, keep
open flames and electrical sparks away from the
battery; do not smoke. Nausea may result if the
gases are inhaled. Unplug the charger from the
electrical outlet before connecting to, or
disconnecting charger leads from battery posts.
Note: Check battery condition weekly or after every
50 hours of operation. Keep terminals and entire
battery case clean because a dirty battery will
discharge slowly. To clean the battery, wash the
entire case with solution of baking soda and water.
Rinse with clear water. Coat the battery posts and
cable connectors with Grafo 112X (skin-over)
grease (Toro Part No. 505-47) or petroleum jelly to
prevent corrosion.
Fuses (Fig. 55)
There are four fuses in the machines electrical
system. They are located below control panel.
– 38 –
CAUTION
Advertisement
Table of Contents
