Table of Contents
Advertisement
Submenu
Setting
[Line Select]
Select [On] to display the waveform of
the line assigned in [Position] below,
when [WFM] is selected.
[Color]: Selects the displayed line
color from among [Red], [Green],
[Blue], [Yellow], [White].
[Position]: Sets the line position.
When the numerical value is
increased, the line will move down;
when decreased, the line will move
up.
[Target]
Select [75%] or [100%]. Switches the
vectorscope target between 75% and
100%.
[Audio Setting]
Submenu
Setting
[SDI Audio Setting]
Sets the audio channel when SDI signal
is input.
[Left Audio]: Selects from channels
[Right Audio]: Selects from channels
When a channel from [CH1] to [CH8]
is selected in [Left Audio], you can
select a channel from [CH1] to [CH8]
in [Right Audio]. When a channel from
[CH9] to [CH16] is selected in [Left
Audio], you can select a channel from
[CH9] to [CH16] in [Right Audio].
You can display the L/R audio levels of
the selected channels. (see [WFM/
ALM/Vector (waveform monitor, audio
level meter, and vectorscope) Setting]
(page 23)).
[Analog Audio
Select an audio format to output from
Output]
speakers, headphone jack, and AUDIO
OUT connector.
[Embedded]: Outputs an audio signal
[Analog]: Outputs an audio signal
Note
The HDMI audio signal is output only from [CH1] or
[CH2].
[CH1] to [CH16].
[CH1] to [CH16].
embedded in SDI or HDMI
signal.
that comes from the AUDIO IN
connector.
[On Screen Tally Setting]
Submenu
Setting
[Tally Bckgnd
The tally is displayed on the screen of
Display]
this unit.
When [Tally Bckgnd Display] is set to
[On], the mat is displayed on the tally
display area. When [Off], the tally is
displayed directly on the video signal.
25
Adjustment Using the Menus
Advertisement
Table of Contents
