Snowthrowing Tips - Toro 38543 Operator's Manual

Figure 23
1. Inner axle hole
2. Outer axle hole and wheel
hub

Snowthrowing Tips

Danger
When the snowthrower is in operation, the
impeller and auger can be rotating and cut off or
injure hands and feet.
Before adjusting, cleaning, repairing and
inspecting the snowthrower, and before
unclogging the discharge chute, stop the engine
and wait for all moving parts to stop. Disconnect
the wire from the spark plug and keep it away
from the plug to prevent someone from
accidentally starting the engine.
Use a stick, not your hands, to remove an
obstruction from the discharge chute.
Stay behind the handles and away from the
discharge opening while operating the
snowthrower.
Keep face, hands, feet, and any other part of
your body or clothing away from concealed,
moving, or rotating parts.
Warning
The auger/impeller may pick up and throw stones,
toys, and other foreign objects, causing serious
personal injury to the operator or to bystanders.
Keep the area to be cleared free of all objects
that could be picked up and thrown by the
auger/impeller.
Keep all children and pets away from area of
operation.
Adjust the skids to match the type of surface being
cleaned. Refer to Adjusting the Skids and the Scraper
on page 20.
3. Axle pin
17
In snowy and cold conditions, some controls and
moving parts may freeze. Do not use excessive force
when trying to operate frozen controls. If you have
difficulty operating any control or part, start the engine
and let it run for a few minutes.
Remove snow as soon as possible after it falls. This
produces the best snow removal results.
Always use the Fast throttle position when throwing
snow.
Overlap each swath to ensure complete snow removal.
Discharge the snow downwind whenever possible.
Do not overload the snowthrower by clearing snow at
too fast a rate. If the engine slows down, shift the
snowthrower into a lower gear to reduce the forward
speed.
In wet or slushy conditions, maintain maximum engine
speed, and do not overload the engine to prevent
clogging the discharge chute.
If the front of the snowthrower tends to ride up, reduce
the forward speed by shifting the snowthrower into a
lower gear. If the front still tends to ride up, lift up on
both handgrips to hold down the front of snowthrower.
If the wheels slip, shift the snowthrower into a lower
gear to reduce the forward speed.
After clearing the snow, let the engine run for a few
minutes to prevent moving parts from freezing. Engage
the auger/impeller to clear any remaining snow from
inside the housing. Shut off the engine, wait for all
moving parts to stop, and remove all ice and snow from
the snowthrower.
With the engine shut off, pull the recoil starter handle
several times to prevent the recoil starter from freezing
up.
When you are not using the snowthrower, close the fuel
shutoff valve and remove the key.