Pc With Ethernet Adapter - D-Link DIR-320 Quick Installation Manual

DIR-320
CONNECTING TO PC

PC with Ethernet Adapter

1. Make sure that your PC is powered off.
2. Connect an Ethernet cable between any of LAN ports located on the back
panel of the router and the Ethernet port of your PC.
3. To connect via an LTE, 3G GSM or CDMA network: connect your USB
modem to the USB port
If you need to connect or change a USB modem to another one when
!
the router is powered on, power off the router, connect the modem to
the USB port, and power on the router.
4. Connect the power cord to the power connector port on the back panel of
the router, then plug the power adapter into an electrical outlet or power
strip.
5. Turn on the router by pressing the ON/OFF button on its back panel.
6. Turn on your PC and wait until your operating system is completely
loaded.
Now you should configure your PC to obtain an IP address automatically (as
DHCP client).
3 It is recommended to use a USB extension cable to connect a USB modem to the
router.
3 located on the left side panel of the router.
Quick Installation Guide
6